Zanussi ZGF 692 C 지침 책자 - 페이지 15

{카테고리_이름} Zanussi ZGF 692 C에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 692 C 16 페이지. Zanussi instruction booklet gas hob zgf 682, zgf 692
Zanussi ZGF 692 C에 대해서도 마찬가지입니다: 지침 책자 (32 페이지)

페이지 인쇄

1. Instructions for the Installer

Commissioning

When the hob has been fully installed it will be necessary

to check the minimum flame setting. To do this, follow

the procedure below.

Turn the gas tap to the MAX position and ignite.

Set the gas tap to the MIN flame position then turn

the control knob from MIN to MAX several times. If

the flame is unstable or is extinguished follow the

procedure below.

Procedure:

Re-ignite the burner and set to MIN.

Remove the control knob and use a thin bladed

screwdriver to turn the adjustment screw until the

flame is steady and does not extinguish, when the

knob is turned from MIN to MAX.

The adjustment screw may be located at the centre

of the gas tap control shaft or on the gas tap body,

left of the control shaft or below (see diagram).

Repeat the adjustment procedure for all burners.

Pressure Testing

Remove left hand pan support and front left burner

cap and crown.

Fit manometer tube over the injector.

Turn on the burner gas supply and ignite another

burner.

The pressure reading should be nominally 20mbar

and must be between 17 mbar and 25mbar.

Turn off the burner supplies.

Conversion from Natural Gas to LPG

IMPORTANT

The replacement/conversion of the gas hob should only

be undertaken by a competent person.

It is important to note that this model is designed for use

with natural gas but can be converted for use with butane

or propane gas providing the correct injectors are fitted

and the gas rate is adjusted to suit.

Method

•

Ensure that the gas taps are in the 'OFF' position

•

Isolate the hob from the electrical supply

•

Remove all pan supports, burner caps, rings, crowns

and control knobs.

Adjustment

•

With the aid of a 7mm box spanner the burner injectors

can then be unscrewed and replaced by the

appropriate LPG injectors.

To adjust the gas rate

With the aid of a thin bladed screwdriver completely

tighten down the by pass adjustment screw, which is

located down the centre of the gas tap control shaft.

Upon completion stick the replacement rating plate on

the under side of the hob.

screw