Zanussi ZGF 692 C 지침 책자 - 페이지 5
{카테고리_이름} Zanussi ZGF 692 C에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 692 C 16 페이지. Zanussi instruction booklet gas hob zgf 682, zgf 692
Zanussi ZGF 692 C에 대해서도 마찬가지입니다: 지침 책자 (32 페이지)
페이지 인쇄Maintenance and Cleaning
Before any maintenance or cleaning can be
carried out, you must DISCONNECT the hob
from the electricity supply.
The hob is best cleaned whilst it is still warm, as spillage
can be removed more easily than if it is left to cool.
The Hob Top
Regularly wipe over the hob top using a soft cloth well
wrung out in warm water to which a little washing up
liquid has been added. Avoid the use of the following:
-
household detergent and bleaches;
-
impregnated pads unsuitable for non-stick
saucepans;
-
steel wool pads;
-
bath/sink stain removers.
Should the hob top become heavily soiled, it is
recommended that a cleaning product such as Hob Brite
or Bar Keepers Friend is used.
Pan Supports
To keep the pan supports in the correct position, they
are hooked into hinges at the back of the hob.
Model ZGF 682: The pan supports can be lifted
for easier cleaning, as shown in Fig. 2.
To remove the pan supports completely, proceed
as shown in Fig. 3.
Model ZGF 692: The hob has two cast iron pan
supports.
Take care when removing them. They are
heavy and could damage the hob or your
kitchen furniture if you let them fall.
Never turn the pan supports on the hinges, this
could damage them.
To remove the pan supports completely, proceed
as shown in Fig. 3.
Wash the pan supports using hot soapy water. If
necessary, a paste cleaner or a soap impregnated steel
wool pad can be used with caution.
After cleaning, be sure to wipe dry with a soft cloth.
The Burners
The burner caps and crowns (Fig. 1) can be removed for
cleaning. Wash the burner caps and crowns using hot
soapy water, and remove marks with a mild paste cleaner.
A well moistened soap impregnated steel wool pad can
be used with caution, if the marks are particularly difficult
to remove. After cleaning, be sure to wipe dry with a soft
cloth.
Ignition electrode
The electric ignition is obtained through a ceramic
"electrode" and a metal electrode (Fig. 1 - letter C). Keep
these components very clean, to avoid lighting difficulties,
and check that the burner crown holes are not
obstructed.
Fig. 2
Fig. 3
5