Zanussi ZGF 759 지침 책자 - 페이지 14

{카테고리_이름} Zanussi ZGF 759에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 759 14 페이지. Gas hob

페이지 인쇄

Servicing

A: Removal Of Hob Top

1. Remove all control knobs, pan supports, burner caps

and burner crowns.

2. Remove 2 screws for each burner.

3. Remove 6 fixing screws from the pan support hinges,

and remove the hinges from the hob.

4. Lift hob top at the rear and disengage it from the

front locators.

B: Removal Of the Hob Taps

(Isolate Electrical Supply)

1. Follow the procedures in Section A.

2. With the aid of a 7mm spanner remove the clamping

bolt from the fixing clamp.

3. Loosen the pipe connection nut from the gas tap with

the aid of a 16mm spanner. Remove fixing clamps.

4. Reassemble in reverse order and carry out leak test.

C: Removal Of Mains Terminal Block

(Isolate Electric Supply)

1. Follow the procedures in Section A.

2. Disconnect supply flex connections from terminal

block.

3. From the underside of the hob remove 1 self tapping

screw from the terminal block.

4. Reassemble in reverse order.

Technical Maintenance

Check at regular intervals the condition and

serviceability of the gas connection hose and pressure

regulator, if any is fitted; in case of malfunction, do

not repair but replace the whole faulty part.

To ensure a smooth and safe operation, it is necessary

to periodically grease the gas taps.

Act as follows:

1) Carry out steps 1 to 4 as explained in "Removal of

Hob Top" (see top of page).

2) Remove screws 1 and 2 (see diagram)

3) Remove the gas tap shaft and flange.

4) Slide out the Venturi tube, clean it thoroughly and

then apply a thin layer of grease of a non-soluble to

hydrocarbons type and suitable for gas taps.

5) Make sure that no axcess grease abstructs the gas

tap holes.

6) Refit everything very carefully following this pro-

cedure in reverse order.

D: Removal Of Burner

1. Follow the procedures in Section A.

2. With the aid a 12mm spanner loosen off the pipe

connection nut.

3. From the underside of the hob remove 2 self tapping

screws from the burner body.

4. Reassemble in reverse order and carry out leak test.

E: Removal of Ignitor

(Isolate Electrical Supply)

1. Follow the procedures in Section A.

2. Remove H.T. leads from the ignitor by pulling tab

connection off. Disconnect supply cable from the

ignitor unit.

3. With the aid of a pair of thin nose pliers, pull the

spring clip sideward off of the underside of the

ignitor

4. Reassemble in reverse order.

F: Removal of Ignitor Switch

(Isolate Electric Supply)

1. Follow the procedures in Section A.

2. Remove the fixing nut from the switch and remove

tab connections.

3. Reassemble in reverse order and check with wiring

diagram for correct reconnection.

FO 1042