Zanussi ZGF 780 IT 지침 책자 - 페이지 18

{카테고리_이름} Zanussi ZGF 780 IT에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 780 IT 28 페이지. Gas hob

Installation

IMPOR T T T T T ANT

IMPOR

ANT

IMPOR

ANT

Any gas installation must be carried out by a GAS SAFE REGISTER

installer.

Please, ensure that, once the hob is installed, it is easily accessible for the

engineer in the event of a breakdown.

The manufacturer will not accept liability, should the above instructions or

any of the other safety instructions incorporated in this instruction booklet

be ignored.

On the end of the shaft,

which includes the G 1/2"

threaded elbow, adjustment

is fixed so that the washer

is fitted between the

components as shown in

the diagram. Screw the

parts together without using

excessive force.

Connection to the gas supply should be with either rigid or semi-rigid pipe, i.e. steel

or copper.

The connection should be suitable for connecting to R 1/2 (1/2 BSP male thread).

When the final connection has been made, it is essential that a thorough leak test is

carried out on the hob and installation.

Ensure that the main connection pipe does not exert any strain on the hob.

It is important to install the elbow correctly, with the shoulder on the

end of the thread, fitted to the hob connecting pipe.

Failure to ensure the correct assembly will cause leakage of gas.

Check to be sure that all connections to the unit are completely gas-tight;

use a soap solution to do this, never a flame.

A) End of shaft with nut

B) Washer

C) Elbow