Zanussi ZGF 780 IT 지침 책자 - 페이지 8

{카테고리_이름} Zanussi ZGF 780 IT에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 780 IT 28 페이지. Gas hob

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply ("off" position)

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before

putting a pan on the pan support.

To light a burner:

turn the relevant knob anti-clockwise to

maximum position (

down to ignite the burner.

Upon ignition, keep the knob pushed

down about 5 seconds. This will

allow the "thermocouple" (see Fig.1 -

letter D) to be heated and the safety

device to be switched off, otherwise

the gas supply would be interrupted.

Then adjust the flame as required.

If the burner accidentally goes out, turn

the control knob to the "off" position

and wait for at least 1 minute before

trying to light the burner again.

If you cannot light the flame even after

several attempts, check the "cap"

(see Fig.1 - letter A) and the"crown"

(see Fig.1 - letter B) are in the correct

position.

To switch off a burner:

To put the flame out, turn the knob to the

symbol (

), then push it

Triple crown burner

A A A A A - Burner cap

B B B B B - Burner crown

C C C C C - Ignition electrode

D D D D D - Thermocouple

Fig. 1