Zanussi ZGF 7820 지침 책자 - 페이지 8

{카테고리_이름} Zanussi ZGF 7820에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 7820 20 페이지. Zanussi instructrion manual gas range zgf 7820

페이지 인쇄

Important safety requirements

This hob must be installed in accordance with the Gas

FITTING THE GAS HOB

Safety (Installation and Use) Regulations (Current Edition)

WITHOUT A COOKER HOOD ABOVE

and the IEE Wiring Regulations (Current Edition).

For appliances installed in the Republic of Ireland please

refer to NSAI- Domestic Gas Installation I.S. 813 Current

Editions and the ETCI Rules for Electrical Installations.

700 mm

Provision for ventilation

400 mm

Detailed recommendations are contained in the following

British Standards Codes Of Practice: B.S. 6172/ B.S.

400 mm

5440, Part 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed sitting room

with a volume of less than 20 m

. If it is installed in a

room of volume less than 5 m

an air vent of effective

area of 110 cm

is required. If it is installed in a room of

volume between 5 m

and 10 m

an air vent of effective

area of 50 cm

is required, while if the volume exceeds

FO 2369*

11 m

no air vent is required. However, if the room has a

door which opens directly to the outside no air vent is

FITTING THE GAS HOB

required even if the volume is between 5 m

and 11 m

. If

WITH A COOKER HOOD ABOVE

there are other fuel burning appliances in the same room,

B.S. 5440 Part 2 Current Edition, should be consulted to

determine the requisite air vent requirements.

For appliances installed in the Republic of Ireland please

refer to the NSAI- Domestic Gas Installation I.S. 813

700 mm

Current Editions Table Four.

400 mm

Location

The hob may be located in a kitchen, a kitchen/diner or

400 mm

bed sitting room, but not in a bathroom or shower room.

Before making the cut out in the worktop ensure that

the edges of the hob that are to be near either a side or

rear wall have a minimum distance of 55 mm. between

the edge of the hob and the wall.

The minimum distance combustible material can be fitted

FO 2231*

above the hob is 400 mm. If it is fitted below 400 mm. a

space of 50 mm. must be allowed from the edges of the

hob. The minimum distance combustible material can

be fitted directly above the hob is 700 mm. A minimum

distance of 100 mm. must be left between the side edges

of the hob and any adjacent cabinets or walls.

For appliances installed in the Republic of Ireland please

refer to NSAI- Domestic Gas Installation I.S 813 Current

Edition Section 7- Permitted Locations of Appliance.