Zanussi ZGF 789 지침 책자 - 페이지 7

{카테고리_이름} Zanussi ZGF 789에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 789 10 페이지.

Installation

IMPORTANT

This appliance must be installed by

qualified personnel.

The manufacturer will not accept liability,

should the above instructions or any of

the other safety instructions incorporated

in this book be ignored.

On the end of the shaft (A) , which includes the GJ

1/2" threaded elbow, an adjustable joint is fixed so

that the washer (B) is fitted between the

components as shown in figure 4.

A drop of paint at both edges of the "L" joint (C) will

evidence that the good seal of the connection has

been tested in the factory.

Before connecting the gas supply pipe to the joint

(C), the installer will ensure that the paint drop is

unbroken and the "L" connector has not been

moved by the vibrations during handling and

transportation.

When the final connection has been made, it is

essential that a thorough leak test is carried out on

the hob and installation.

Ensure that the main connection pipe does not

exert any strain on the hob.

Cut Out Size

The dimensions of the cut-out are given in figure

FO 1010

A) End of shaft with nut

B) Washer

C) Adjustable joint

Rectangular cut-out size for hob

Dimensions are given in mm.

FO 2038

Fig. 4

Fig. 5