Zanussi ZGF 983 지침 책자 - 페이지 3

{카테고리_이름} Zanussi ZGF 983에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGF 983 10 페이지. Zanussi cooktop user manual

페이지 인쇄
Zanussi ZGF 983 지침 책자
Contents
1. Instruction for the User ............. Pag.
3. Technical Data ........................... Pag.

1. Instruction for the User

HOB BURNERS CONTROL KNOBS
The hob burners control knobs are situated on the hob
front panel. The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
there is minimum gas supply
LIGHTING THE BURNERS
•
For easier lighting, proceed before putting a pan
on the pan support.
Press the automatic ignition switch marked with a
small spark. Push the relevant burner control knob
down and turn it anti-clockwise until it reaches the
"maximum" position.
After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the
"thermocouple" (Fig. 1 lett. D) to be heated and the
safety device to be switched off, otherwise the gas
supply would be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 lett. A) and the
"crown" (Fig. 1 lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol
•
Always turn the flame down or put it out before
taking the pans off the burner.
USING THE HOB CORRECTLY
To ensure maximum burner efficiency, it is strongly
recommended that you use only pots and pans with a
bottom fitting the size of the burner used, so that flame
will not spread beyond the bottom of the vessel (see the
table beside).
It is also advisable, as soon as a liquid starts boiling, to
turn down the flame so that it will barely keep the liquid
simmering.
•
Use only pans or pots with flat bottom.
34
34
5. Electrical Connection ................ Pag.
35
36
7. Building In .................................. Pag.
36
Guarantee ................................... Pag.
Carefully supervise cookings with fats or oil,
since these types of foodstuff can result in a fire,
if over-heated.
Fig. 1
.
Burner
Double Crown
Big (rapid)
Medium (semirapid)
Small (Auxiliary)
FO 0204
minimum
diameter
180 mm
160 mm
120 mm
80 mm
37
38
39
42
maximum
diameter
260 mm
260 mm
220 mm
160 mm