Zanussi ZGG 643 사용 설명서 - 페이지 7

{카테고리_이름} Zanussi ZGG 643에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG 643 23 페이지.
Zanussi ZGG 643에 대해서도 마찬가지입니다: 지침 책자 (11 페이지)

INSTALLATION

Any gas installation must be carried out by qualified personnel, and in

accordance with existing rules and regulations.

The relevant instructions are to be found in the second section of this manual.

Please, ensure that, once the hob is installed, it is easily accessible for the

engineer in the event of a breakdown.

The manufacturer will not accept liability, should the above instructions or any

of the other safety instructions incorporated in this book be ignored.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to remove any protective materials,

which were put on in the factory.

Operation

Hob Burners

To light a burner:

turn the relevant knob anticlockwise to

maximum position and push down the knob to

ignite.

After lighting the flame, keep the knob pushed

down for about 5 seconds. This will allow the

"thermocouple" (Fig. 2 - lett. D) to be heated

and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then, check the flame is regular and adjust it

as required.

If you cannot light the flame even after several

attempts, check the "cap" (Fig. 1 - lett. A) and

"crown" (Fig. 1 - lett. B) are in the correct position.

To put the flame out, turn the knob to the symbol

In the absence of electricity, ignition can

occur without the electrical device; in this case approach the burner with a

flame, push the relevant knob down and turn it anti-clockwise until it reaches

the"maximum" position.

When switching on the mains, after installation or a power cut, it is quite normal

for the spark generator to be activated automatically.

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1