Zanussi ZGG 646 ICN 지침 책자 - 페이지 3
{카테고리_이름} Zanussi ZGG 646 ICN에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG 646 ICN 12 페이지.
페이지 인쇄
Contents
For the User
Guide to Use the instructions
The following symbols will be found in the text to guide
you throughout the Instructions:
Safety Instructions
! ! ! ! !
Step by step instructions for an operation
Hints and Tips
Environmental Information
Instruction for the User
Hob Burners Control Knobs
The hob burners control knobs are situated on the hob
front panel. The symbols on the knobs mean that :
•
there is no gas supply
there is maximum gas supply
there is minimum gas supply
Lighting the Burners
•
For easier lighting, proceed before putting a pan
on the pan support.
! ! ! ! !
Push in the relevant knob and turn it anticlockwise
to "maximum position". After lighting the flame,
keep the knob pushed down for about 5 seconds.
This will allow the "thermocouple" (Fig. 1 - lett. D)
to be heated and the safety device to be switched
off, otherwise the gas supply would be interrupted.
Then, check the flame is regular and adjust it as
required.
If you cannot light the flame even after several
attempts, check the "cap" (Fig. 1 - lett. A) and
"crown" (Fig. 1 - lett. B) are in the correct position.
To put the flame out, turn the knob to the symbol .
•
Always turn the flame down or put it out before
taking the pans off the burner.
For the Installer
2
3
4
5
MANUFACTURER:
ELECTROLUX HOME PRODUCTS ITALY S.p.A.
Viale Bologna, 298
47100 FORLÌ (Italy)
This appliance complies with the following
E.E.C. Directives:
-
73/23 - 90/683 (Low Voltage Directive);
-
89/336 (Electromagnetical Compatibility Directive);
-
93/68 (General Directives)
and subsequent modifications.
A - Burner cap
•
B - Burner crown
C - Ignition candle
D - Thermocouple
FO 0204
6
6
7
8
9
10
Fig. 1
3