Zanussi ZGG 78 지침 책자 - 페이지 11

{카테고리_이름} Zanussi ZGG 78에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG 78 11 페이지.

페이지 인쇄

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability should these

safety measures not be observed.

This hob is designed to be connected to a 230 V 50

Hz AC electrical supply.

Before the appliance is connected:

1) check that the main fuse and the domestic installation

can support the load (see the rating label);

2) check that the power supply is properly earthed in

compliance with the current rules;

3) check the socket or the double pole switch used for

the electrical connection can be easily reached with

the appliance built in the forniture unit. make sure the

electricity supply voltage is the same as that indicated

on the hob rating plate. The rating plate is located on

the bottom of the hob. A copy is attached on the back

cover of this book.

The hob is supplied with a 3 core flexible supply cord

incorporating a plug. Connect the plug to an adequate

socket.

Commissioning

When the hob has been fully installed it will be necessary

to check the minimum flame setting. To do this, follow

the procedure below.

Turn the gas tap to the MAX position and ignite.

Set the gas tap to the MIN flame position then turn

the control knob from MIN to MAX several times. If

the flame is unstable or is extinguished follow the

procedure below.

Procedure:

Re-ignite the burner and set to MIN.

Remove the control knob.

To adjust, use a thin bladed screwdriver and turn

the adjustment screw (see diagram) until the flame

is steady and does not extinguish, when the knob

is turned from MIN to MAX. Repeat this procedure

for all burners.

Permanent Connection

In the case of a permanent connection, it is necessary

that you install a double pole switch between the hob

and the electricity supply (mains), with a minimum gap

of 3 mm. between the switch contacts and of a type

suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth

cable at any point.

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

By-pass screw

Fig. 15