Zanussi ZGG62414 사용자 설명서 - 페이지 9
{카테고리_이름} Zanussi ZGG62414에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG62414 20 페이지. Product manaul
Zanussi ZGG62414에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (48 페이지)
페이지 인쇄
detergent. After cleaning, wipe the hob dry
with a soft cloth.
• To clean the enamelled parts, cap and
crown, wash them with warm soapy water
and dry them carefully before you put them
back on.
Cleaning the spark plug
This feature is obtained through a ceramic
ignition candle with a metal electrode. Keep
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
There is no spark when you try to
activate the spark generator.
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
www.zanussi.com
these components well clean to prevent difficult
lighting and check that the burner crown holes
are not obstructed.
Periodic maintenance
Speak to your local Authorised Service Centre
periodically to check the conditions of the gas
supply pipe and the pressure adjuster, if fitted.
Possible cause
The hob is not connected to an
electrical supply or it is connec-
ted incorrectly.
The fuse is blown.
Burner cap and crown are placed
incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
technician or dealer will not be free of charge,
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Remedy
Check if the hob is correctly con-
nected to the electrical supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Place the burner cap and crown
correctly.
After lightning the flame, keep the
knob pushed for equal or less
than 10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
9