Zanussi ZGG649 사용자 설명서 - 페이지 5

{카테고리_이름} Zanussi ZGG649에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG649 12 페이지. Zanussi cooktop user manual
Zanussi ZGG649에 대해서도 마찬가지입니다: 지침 책자 (12 페이지)

페이지 인쇄

Adjustment of minimum level

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the control knob.

4. With a thin screwdriver, adjust the by-pass screw po-

sition. If you change from natural gas 20 mbar to liq-

uid gas, fully tighten the adjustment screw in. If you

change from liquid gas to natural gas 20 mbar, undo

the by-pass screw approximately 1/4 of a turn.

Minimum adjustment screw

5. Make sure the flame does not go out when you quick-

ly turn the knob from the maximum position to the

minimum position.

Electrical connection

• Ground the appliance according to safety precautions.

• Make sure that the rated voltage and type of power on

the rating plate agree with the voltage and the power of

the local power supply.

• This appliance is supplied with a mains cable and

plug.

Building In

min. 600 mm

min. 450 mm

min. 55 mm

30 mm

• Any electrical component must be installed or replaced

• Always use a correctly installed shockproof socket.

• Make sure that there is an access to the mains plug af-

• Do not pull the mains cable to disconnect the appli-

• The appliance must not be connected with an extension

• The power cable must be placed in such a way that it

• Connect the appliance to the mains with a device that

• None of a parts of the connection cable can not get a

Replacement of the connection cable

To replace the connection cable use only H05V2V2-F T90

or equivalent type. Make sure that the cable section is ap-

plicable to the voltage and the working temperature. The

yellow/green earth wire must be approximately 2 cm lon-

ger than the brown (or black) phase wire.

min. 650 mm

550 mm

A - supplied seal

by the Service Force Centre technician or qualified

service personnel.

ter installation.

ance. Always pull the mains plug.

cable, an adapter or a multiple connection (risk of fire).

Check that the ground connection is in conformity with

the standard and regulations force.

does not touch any hot part.

lets to disconnect the appliance from the mains at all

poles with a contact opening width of minimum 3 mm,

eg. automatic line protecting cut-out, earth leakage

trips or fuse.

temperature 90°C. The blue neutral cable must be con-

nected to the terminal block label with "N". The brown

(or black) phase cable (fitted in the terminal block con-

tact marked with "L") must always be connected to the

live phase.

10 mm

3 mm

11 mm