Zanussi ZGG649 지침 책자 - 페이지 11
{카테고리_이름} Zanussi ZGG649에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG649 12 페이지. Zanussi cooktop user manual
Zanussi ZGG649에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)
페이지 인쇄
Servicing
A: Removal Of Hob Top
1. Remove the panstands and each burner cap
and crown.
2. Lift the hob from off the working top.
3. Remove the two self tapping screws from each
burner and the two fixing screws on the right
hand side of the hob.
B: Removal Of the Hob Taps
(Isolate Electric Supply)
1. Follow the procedures in Section A.
2. With the aid of a 7mm spanner remove the
clamping bolt from the fixing clamp.
3. Loosen the pipe connection nut from the gas
tap with the aid of a 16mm spanner. Remove
fixing clamps.
4. Reassemble in reverse order and carry out leak
test.
C: Removal Of Mains Terminal
Block
(Isolate Electric Supply)
1. Follow the procedures in Section A.
2. Disconnect supply flex connections from
terminal block.
3. From the underside of the hob remove 1 self
tapping screw from the terminal block.
4. Reassemble in reverse order.
D: Removal Of Burner
1. Follow the procedures in Section A.
2. With the aid of a 12mm spanner loosen off the
pipe connection nut.
3. From the underside of the hob remove 2 self
tapping screws from the burner body.
4. Reassemble in reverse order and carry out leak
test.
E: Removal Of Ignitor Unit
(Isolate Electric Supply)
1. Follow the procedures in Section A.
2. Disconnect H.T. leads and the ignition switches
connector.
3. With the aid of a pair of thin nose pliers, pull
the spring clip sidewards off of the underside
of the ignitor.
4. Reassemble in reverse order and check with
wiring diagram for correct reconnection.
F: Remove Taps Ignition Switches
(Isolate Electric Supply)
1. Follow the procedures in Section A.
2. Disconnect the switches connector from the
ignitor unit and remove the supply cables
pulling the tabs connection off.
3. Reassemble in reverse order and check with
wiring diagram for correct reconnection.
11