Zanussi ZGG65414 사용자 설명서 - 페이지 8

{카테고리_이름} Zanussi ZGG65414에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG65414 16 페이지.
Zanussi ZGG65414에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (21 페이지), 사용자 설명서 (16 페이지)

페이지 인쇄

necessary, remove stubborn stains with a

paste cleaner.

3. After you clean the pan supports, make sure

that they are in correct positions.

4. For the burner to operate correctly, make

sure that the arms of the pan supports are

aligned with the centre of the burner.

Cleaning the hob

• Remove immediately: melted plastic,

plastic foil, and food with sugar. If not, the

dirt can cause damage to the hob.

• Remove when the hob is sufficiently

cool: limescale rings, water rings, fat stains,

Troubleshooting

WARNING!

Refer to Safety chapters.

What to do if...

Problem

There is no spark when you try to

activate the spark generator.

The flame extinguishes immedi-

ately after ignition.

The flame ring is uneven.

• To clean the enamelled parts, cap and

Cleaning the spark plug

This feature is obtained through a ceramic

ignition candle with a metal electrode. Keep

these components well clean to prevent difficult

lighting and check that the burner crown holes

are not obstructed.

Periodic maintenance

Speak to your local Authorised Service Centre

periodically to check the conditions of the gas

supply pipe and the pressure adjuster, if fitted.

Possible cause

The hob is not connected to an

electrical supply or it is connec-

ted incorrectly.

The fuse is released.

Burner cap and crown are placed

incorrectly.

Thermocouple is not heated up

sufficiently.

Burner crown is blocked with

food residues.

shiny metallic discoloration. Clean the hob

with a moist cloth and some detergent. After

cleaning, rub the hob dry with a soft cloth.

crown, wash them with warm soapy water

and dry them carefully before you put them

back.

Check if the hob is correctly con-

nected to the electrical supply.

Make sure that the fuse is the

cause of the malfunction. If the

fuse releases again and again,

contact a qualified electrician.

Place the burner cap and crown

correctly.

After lightning the flame, keep the

knob pushed for equal or less

than 10 seconds.

Make sure that the injector is not

blocked and the burner crown is

clean.

Remedy