Zanussi ZGG66424 사용자 설명서 - 페이지 6

{카테고리_이름} Zanussi ZGG66424에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG66424 16 페이지. Gas hob
Zanussi ZGG66424에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (21 페이지)

페이지 인쇄

4. With a thin screwdriver, adjust the by-pass

screw position.

The by-pass screw

– If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

– If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2 of

a turn for Triple Crown burner).

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• The electrical work necessary to install the

appliance must be done by a qualified elec-

trician or competent person, according to the

current regulations.

• The appliance must be earthed.

• Always use a correctly installed shockproof

socket.

• Make sure that there is access to the mains

plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• The appliance must not be connected with

an extension cable, an adapter or a multiple

socket. There is a risk of fire. Make sure that

the ground connection complies with the

standards and regulations force.

• The power cable must not touch any hot

parts.

• The electrical installation must have an isola-

tion device which lets you disconnect the ap-

pliance from the mains at all poles. The isola-

tion device must have a contact opening

width of minimum 3 mm.

• You must have the correct isolation devices:

line protecting cut-outs, fuses (screw type

fuses removed from the holder), earth leak-

age trips and contactors.

• The connection cable parts must not be

heated to a temperature above 90°C.

Electrical Requirements

Permanent electrical installation must comply

with the latest I.E.E. Regulations and local Elec-

tricity Board regulations. For your own safety

the installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National In-

spection Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer declines any liability if

these safety measures are not observed.

The appliance must be connected to a 230 V

50 Hz AC electrical supply.

Before activating the appliance, make sure the

electrical supply voltage is the same as that in-

dicated on the rating plate. The rating plate is

located on the bottom of the appliance.

The appliance is supplied with a 3 core flexible

supply cord with a 3 amp plug. If it is necessary

to change the fuse, use a 3 amp ASTA-ap-

proved (BS 1362) fuse.