Zanussi ZGG96624 사용자 설명서 - 페이지 11

{카테고리_이름} Zanussi ZGG96624에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGG96624 16 페이지. Hob
Zanussi ZGG96624에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (48 페이지), 사용자 설명서 (44 페이지)

페이지 인쇄

screw approximately 1/4 of a turn (1/2 of a

turn for Triple Crown burner).

Warning! Make sure the flame does not

go out when you quickly turn the knob

from the maximum position to the minimum

position.

Electrical connection

• Ground the appliance according to safety

precautions.

• Make sure that the rated voltage and type of

power on the rating plate agree with the volt-

age and the power of the local power supply.

• This appliance is supplied with a mains ca-

ble. It has to be supplied with a correct plug,

able to support the load marked on the rating

plate. The plug has to be fitted in a correct

socket.

• Any electrical component must be installed

or replaced by the Service Force Centre

technician or qualified service personnel.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• The appliance must not be connected with

an extension cable, an adapter or a multiple

connection (risk of fire). Check that the

ground connection is in conformity with the

standard and regulations force.

• The power cable must be placed in such a

way that it does not touch any hot part.

• Connect the appliance to the mains with a

device that lets to disconnect the appliance

from the mains at all poles with a contact

opening width of minimum 3 mm, eg. auto-

matic line protecting cut-out, earth leakage

trips or fuse.

• None of a parts of the connection cable can

not get a temperature 90 °C. The blue neu-

tral cable must be connected to the terminal

block label with "N". The brown (or black)

phase cable (fitted in the terminal block con-

tact marked with "L") must always be con-

nected to the live phase.

www.zanussi.com

Replacement of the connection cable

To replace the connection cable use only

H05V2V2-F T90 or equivalent type. Make sure

that the cable section is applicable to the volt-

age and the working temperature. The yellow/

green earth wire must be approximately 2 cm

longer than the brown (or black) phase wire.

Building In

min. 450 mm

min. 55 mm

30 mm

10 mm

3 mm

A) supplied seal

B) supplied brackets

Caution! Install the appliance only on a

worktop with flat surface.

Possibilities for insertion

Kitchen unit with door

The panel installed below the hob must be easy

to remove and let an easy access in case a

technical assistance intervention is necessary.

min. 650 mm

830 mm

27 mm