Zanussi ZGH62414XS 사용자 설명서 - 페이지 9
{카테고리_이름} Zanussi ZGH62414XS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGH62414XS 16 페이지.
Zanussi ZGH62414XS에 대해서도 마찬가지입니다: 사용자 설명서 (21 페이지)
페이지 인쇄
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
A
MOD.
PROD.NO.
SER.NO
DATA
A) Stick it on Guarantee Card and send this
part (if applicable).
B) Stick it on Guarantee Card and keep this
part (if applicable).
Installation
WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Important safety requirements
This hob must be installed in accordance with
the Gas Safety (Installation and Use)
Regulations (Current Edition) and the IEE
Wiring Regulations (Current Edition).
www.zanussi.com
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Labels supplied with the accessories
bag
Stick the adhesive labels as indicated below:
C
MOD.
PROD.NO.
SER.NO.
0049
C) Stick it on instruction booklet.
For appliances installed in the Republic of
Ireland please refer to NSAI- Domestic Gas
Installation I.S. 813 Current Editions and the
ETCI Rules for Electrical Installations.
Provision for ventilation
Detailed recommendations are contained in the
following British Standards Codes Of Practice:
B.S. 6172/B.S. 5440, Par. 2 and B.S. 6891
Current Editions.
The hob should not be installed in a bed sitting
room with a volume of less than 20 m³. If it is
installed in a room of volume less than 5 m³ an
air vent of effective area of 100 cm² is required.
If it is installed in a room of volume between 5
m³ and 10 m³ an air vent of effective area of 50
cm² is required, while if the volume exceeds 11
m³ no air vent is required.
TYPE
IP20
9