Zanussi ZGL 62 IT 지침 책자 - 페이지 8

{카테고리_이름} Zanussi ZGL 62 IT에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGL 62 IT 32 페이지.

Operation

Lighting the burners

For easier lighting,

s u p p o r t .

To light a burner:

push the electric ignition button which is marked by a little spark.

At the same time, turn the relevant control knob anti-clockwise to

maximum position and keep it pushed down about 5 seconds. This will

allow the "thermocouple" (see Fig. 1 - lett. D) to be heated and the safety

device to be switched off, otherwise the gas supply would be interrupted.

Then, check that the flame is regular adjust it as required.

If the burner does not ignite, turn the control

knob to zero, and try again.

If you cannot light the flame even after

severalattempts, check the "cap" (Fig. 1

lett. A) and the"crown" (Fig. 1 lett. B) are in

the correct position.

When switching on the mains, after

installation or a power cut, it is quite normal

for the spark generator to be activated

automatically.

In the absence of electricity, ignition

In the absence of electricity

can occur without the electrical device; in

this case, approach the burner with a

flame, push the relevant knob down and

turn it anti-clockwise until it reaches the

maximum position.

Do not keep the control knob pressed

for more than 15 seconds. If the burner does not light even

after 15 seconds, release the control knob, turn it the "off"

position and wait for at least one minute before trying to light

the burner again.

proceed before putting a pan on the pan

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

Fig. 1