Zanussi ZGL 646 지침 책자 - 페이지 7

{카테고리_이름} Zanussi ZGL 646에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGL 646 11 페이지.
Zanussi ZGL 646에 대해서도 마찬가지입니다: 지침 책자 (13 페이지)

Electrical Connection

The appliance is designed to be connected to 230 V

monophase electricity supply.

The connection must be carried out in compliance with

the laws and regulations in force.

Before the appliance is connected:

1) check that the main fuse and the domestic installation

can support the load (see the rating label);

2) check that the power supply is properly earthed in

compliance with the current rules;

3) check the socket or the double pole switch used for

the electrical connection can be easily reached with

the appliance built in the forniture unit.

The appliance is supplied with a connection cable. This

has to be provided with a proper plug, able to support the

load marked on the identification plate. The plug has to

be fitted in a proper socket.

If connecting the appliance directly to the electric system,

it is necessary that you install a double pole switch

between the appliance and the electricity supply, with a

minimum gap of 3 mm. between the switch contacts and

of a type suitable for the required load in compliance with

the current rules.

The connection cable has to be placed in order that, in

each part, it cannot reach a temperature 90 °C higher than

the room temperature.

The brown coloured phase cable (fitted in the terminal

block contact marked with "L") must always be connected

to the network phase.

Replacement of the voltage cable

Only cable types H05RR-F, H05V2V2-F T90 or H05 BB-F

must be used. The cable section must be suitable to the

voltage and the working temperature.

The yellow/green earth wire must be approximately 2 cm.

longer than the phase wires (Fig. 6).

YES

FO 0238

FO 0073

RIGID COPPER PIPE OR

FLEXIBLE PIPE IN STAINLESS

STEEL

Fig. 5

Neutral

Earth (yellow/green)

Fig. 6