Zanussi ZGL 66 지침 책자 - 페이지 10

{카테고리_이름} Zanussi ZGL 66에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGL 66 11 페이지.

Building In

Mod. ZGL 66

These hobs can be inserted in a built-in kitchen unit

whose depth is between 550 and 600 mm. The hobs

dimensions are shown in the relevant diagram.

The edge of the cut out must have a minimum distance

from the rear wall of 55 mm.

If there are side walls, or sides of the furniture unit near

the hob, the cut out edges must have a minimum

distance of 100 mm.

Hanging forniture units or hoods must be placed at 650

mm. minimum from the hob.

= Auxiliary burner

= Semirapid burner

= Rapid Burner

= Electric hotplate

Fitting the hob to the worktop

The hobs can be installed in a kitchen unit with an

opening for insertion whose dimensions are shown in

Fig. 9. To install the hob, proceed as follows:

1) Remove the pan supports, the burners caps and

crowns and turn the hob upside down, taking care the

ignition candles are not damaged in this operation.

2) Place the sealing gasket (supplied with the hob) on

the edges of the cut out: place it exactly on the front

and rear edge, taking care that the sealings meet

without overlapping;

3) Fix the hob with the relevant screws (Fig. 10). The

traction of the screws is able to trace the sealing, any

excess of which can be easily removed.

The edge of the hob forms a double labyrinth seal which

provides a total guarantee against infiltration of liquids.

1 0

Mod. ZXL 66

Dimensions are given in millimeters

FO 2098

Fig. 9

FO 0199

Fig. 10

a) Sealing gasket

550