Zanussi ZGM62444XA 사용자 설명서 - 페이지 12

{카테고리_이름} Zanussi ZGM62444XA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGM62444XA 37 페이지.
Zanussi ZGM62444XA에 대해서도 마찬가지입니다: 사용자 설명서 (37 페이지)

페이지 인쇄

ADJUSTMENT OF MINIMUM LEVEL

To adjust the minimum level of the burners:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the bypass

screw position (A).

5. If you change:

•

from natural gas G20 20 mbar to liquid gas,

fully tighten the bypass screw in.

•

from liquid gas to natural gas G20 20 mbar,

undo the bypass screw approximately 1/4

of a turn.

WARNING! Make sure the flame does

not go out when you quickly turn the

knob from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

•

Make sure that the rated voltage and type of

power on the rating plate agree with the voltage

and the power of the local power supply.

•

This appliance is supplied with a mains cable. It

has to be supplied with a correct plug which

can hold the load that the rating plate rates.

Make sure that you install the plug in a correct

socket.

•

Always use a correctly installed shockproof

socket.

•

Make sure that there is an access to the mains

plug after the installation.

•

Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug.

•

There is a risk of fire when the appliance is in

connection with an extension cable, an adapter

or a multiple connection. Make sure that the

ground connection agrees with the standards

and regulations.

•

Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a

letter "N" on it. Connect the brown (or

black) phase cable to the terminal

which has a letter "L". Keep the phase

cable connected at all times.

CONNECTION CABLE

To replace the connection cable use only the

special cable or its equivalent. The cable type is:

H05V2V2-FT90.

Make sure that the cable section is applicable to

the voltage and the working temperature. The

yellow / green earth wire must be approximately 2

cm longer than the brown (or black) phase wire.

ASSEMBLY