Zanussi ZGS 645 사용 설명서 - 페이지 7

{카테고리_이름} Zanussi ZGS 645에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGS 645 21 페이지.
Zanussi ZGS 645에 대해서도 마찬가지입니다: 사용자 설명서 (40 페이지)

Operation

Hob burner control knobs

The symbols on the knobs mean:

= no gas supply

= maximum gas supply

= minimum gas supply

For easier lighting, proceed before

putting a pan on the pan support.

Lighting the burners

To light a burner, turn the relevant knob

anticlockwise to maximum position (

push down the knob to ignite.

After lighting the flame, keep the knob

pushed down for about 5 seconds. This will

allow the "thermocouple" (Fig. letter D) to be

heated and the safety device to be switched off,

otherwise the gas supply would be interrupted.

Then, check the flame is regular and adjust it

as required.

If you cannot light the flame even after

several attempts, check the "cap" and "crown"

are in the correct position.

In the absence of electricity, ignition can

occur without the electrical device; in this case

approach the burner with a flame, push the re-

levant knob down and turn it anti-clockwise until

it reaches the "maximum" position.

To switch off burners

To put the flame out, turn the knob to the

symbol ( ).

Take care when frying food in hot oil or

fat, as the overheated splashes could

easily ignite.

When switching on the mains, after instal-

lation or a power cut, it is quite normal for

the spark generator to be activated auto-

matically.

) and