Zanussi ZGX65424XA 사용자 설명서 - 페이지 8

{카테고리_이름} Zanussi ZGX65424XA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZGX65424XA 20 페이지. Hob

페이지 인쇄

• Be very careful when you replace the

pan supports to prevent the hob top

from damage.

After cleaning, dry the appliance with a soft

cloth.

Removing the dirt:

1. – Remove immediately: melting plastic,

plastic foil, and food containing sugar.

– Stop the appliance and let it cool

down before you clean: limescale rings,

water rings, fat stains, shiny metallic dis-

colorations. Use a special cleaner appli-

cable for surface of hob.

Troubleshooting

Problem

There is no spark when lighting the

gas

The flame is blow out immediately

after ignition

The gas ring burns unevenly

If there is a fault, first try to find a solution to the

problem yourself. If you cannot find a solution to

the problem yourself, speak your dealer or the

local Service Force Centre.

If you operated the appliance incorrectly, or

the installation was not carried out by a

2. Clean the appliance with a damp cloth and

3. At the end rub the appliance dry with a

The stainless steel can become tarnished if it is

too much heated. Refer to this you must not

cook with potstones, earthenware pans or cast

iron plates.

Cleaning of the spark plug

This feature is obtained through a ceramic igni-

tion candle with a metal electrode. Keep these

components well clean to prevent difficult light-

ing and check that the burner crown holes are

not obstructed.

Periodic maintenance

Periodically speak your local Service Force

Centre to check the conditions of the gas sup-

ply pipe and the pressure adjuster, if fitted.

Possible cause

• There is no electrical supply

• Burner cap and crown are

placed uneven

• Thermocouple is not heated suf-

ficient

• Burner crown is blocked with

food residues

registered engineer, the visit from the customer

service technician or dealer may not take place

free of charge, even during the warranty period.

some detergent.

clean cloth.

• Make sure that the unit is con-

nected and the electrical supply

is switched on.

• Control the fuse. If the fuse is

released more than one time, re-

fer to a qualified electrician.

• Make sure that the burner cap

and crown are in correct posi-

tions.

• After lightning the flame, keep

the knob pushed for equal or

less than 10 seconds.

• Make sure that the injector is

not blocked and the burner

crown is clear of food particles.

Remedy