Zanussi ZIAN844K 사용자 설명서 - 페이지 11
{카테고리_이름} Zanussi ZIAN844K에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZIAN844K 24 페이지.
페이지 인쇄
When the function detects the boiling point
the hob emits an acoustic signal and the heat
level automatically changes to 5.
If all cooking zones are already
in use or there is some residual
heat on all of them, the hob
emits a beep sound, the
indicators above
the function does not start.
To deactivate the function touch
function deactivates and the heat setting
goes down to 0) or touch the control bar and
adjust the heat setting manually.
The Pause function and lifting of
the pot deactivate BoilAssist.
5.5 Automatic Heat Up
Activate this function to get a desired heat
setting in a shorter time. When it is on, the
zone operates on the highest setting in the
beginning and then continues to cook at the
desired heating setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch
(
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the
heat setting.
5.6 PowerBoost
This function makes more power available to
the induction cooking zones. The function
can be activated for the induction cooking
zone only for a limited period of time. After
this time the induction cooking zone
automatically sets back to the highest heat
setting.
Refer to "Technical data"
chapter.
To activate the function for a cooking
zone: touch
.
To deactivate the function: change the
heat setting.
blink and
(the
comes on). Immediately
comes on.
5.7 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function or change the
time: touch
or
time (00 - 99 minutes). When the indicator of
the cooking zone starts to flash, the time
counts down.
To see the remaining time: touch
the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
To deactivate the function: touch
the cooking zone and then touch
remaining time counts down to 00. The
indicator of the cooking zone disappears.
When the countdown ends, an
acoustic signal sounds and 00
flashes. The cooking zone
deactivates.
To stop the sound: touch
• Minute Minder
You can use this function when the hob is
activated and the cooking zones do not
operate. The heat setting display shows
To activate the function: touch
touch
or
of the timer to set the time.
When the time finishes, an acoustic signal
sounds and 00 flashes.
To stop the sound: touch
The function has no effect on the
operation of the cooking zones.
5.8 Pause
This function sets all cooking zones that
operate to the lowest heat setting.
of the timer to set the
to set
to set
. The
.
and then
.
ENGLISH
.
11