Zanussi ZIE6004F 사용자 설명서 - 페이지 3

{카테고리_이름} Zanussi ZIE6004F에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZIE6004F 12 페이지. Ceramic glass induction hob

페이지 인쇄

Installation instructions

Before the installation , note down the serial num-

ber (Ser. Nr.) from the rating plate. The rating

plate of the appliance is on its lower casing.

ZANUSSI

ZIE6004F

55 GAD D5 AU

Safety instructions

Warning! You must read these!

Make sure that the appliance is not damaged

because of transportation. Do not connect a damaged

appliance. If it is necessary, speak to the supplier.

Only an authorised service technician can install,

connect or repair this appliance. Use only original spare

parts.

Only use built-in appliances after you assemble the

appliance into correct built-in units and work surfaces

that align to the standards.

Do not change the specifications or modify this

product. Risk of injury and damage to the appliance.

Fully obey the laws, ordinances, directives and

standards in force in the country where you use the

appliance (safety regulations, recycling regulations,

electrical safety rules etc.)!

Keep the minimum distances to other appliances and

units!

Install anti-shock protection, for example install the

drawers only with a protective floor directly below the

appliance!

Protect the cut surfaces of the worktop against moisture

with a correct sealant!

Seal the appliance to the work top with no space left

with a correct sealant!

942 116 604

220-240 V

6.9 kW

Induction 6.9 kW

Protect the bottom of the appliance from steam and

moisture, e.g. from a dishwasher or oven!

Do not install the appliance adjacent to doors and

below windows! If not, hot cookware can be hit off the

hob when you open doors or windows.

Warning! Risk of injury from electrical current.

Carefully obey the instructions for electrical

connections.

• The electrical mains terminal is live.

• Make electrical mains terminal free of voltage.

• Install correctly to give anti-shock protection.

• Loose and incorrect plug and socket connections

can make the terminal become too hot.

• A qualified electrician must install the clamping con-

nections correctly.

• Use a strain relief clamp on cable.

• Use the correct mains cable of type H05BB-F Tmax

90°C (or higher) for a single-phase or two-phase con-

nection.

• Replace the damaged mains cable with a special ca-

ble (type H05BB-F Tmax 90°C; or higher). Speak

your local Service Force Centre.

The appliance must have the electrical installation

which lets you disconnect the appliance from the mains

at all poles with a contact opening width of minimum 3

mm.

You must have correct isolation devices: line protecting

cut-outs, fuses (screw type fuses removed from the hold-

er), earth leakage trips and contactors.