Zanussi ZKF641H 운영 및 설치 매뉴얼 - 페이지 7

{카테고리_이름} Zanussi ZKF641H에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZKF641H 16 페이지. Electric ceramic hob

페이지 인쇄

Before cleaning, make sure that the hob is cool and

disconnected from the power supply.

Never use aggressive or abrasive agents,

such as oven sprays, stain or rust

removers, scouring powder, or sponges

with an abrasive effect.

Special cleaning agents such as Vitroclen and

ceramic glass scrapers are available from

department stores and electrical specialists.

Cleaning after each use

• Slight, non-burnt soiling can be wiped off with a

damp cloth.

• Burnt soiling has to be removed with a scraper.

Afterwards wipe off the ceramic glass surface

with a damp cloth and Vitroclen.

Stain removal

• Light metallic stains (aluminium residues) can

be removed from the cooking zone with a

ceramic hob cleaning agent such as Vitroclen.

• Sugar solutions, food stuffs with a high sugar

content, plastics, or kitchen foil must be

removed immediately with a scraper. If this type

of soilage is not removed immediately it can

cause irreparable damage to the ceramic glass

surface. When the surface has cooled wipe

over with a damp cloth and Vitroclen.

• Before using any detergent or cleaning agent on

the ceramic glass surface, ensure they are

recommended for use on ceramic hobs.

• Do not apply any cleaning agents to hot cooking

zones. Ensure that any residues are wiped off

before the cooking zones are used again.

... when a chemical cleansing agent is not

sufficient.

... when dark stains have appeared.

... when metallic discolouration appears on the

cooking surface.

... when the surface shows scratches or hollows.

Special Problems

Use a glass scraper to aid cleaning.

If cleaning with a glass scraper and Vitroclen does

not help, the décor has been cleaned with an

unsuitable cleaning agent or scoured by rough

ban bases.

The cleansing agents that were used were for the

most part unsuitable. The discolouration can only

be removed with difficulty using Vitroclen.

These flaws are caused by scratching or melted

objects and cannot be removed, however, this

does not reduce the performance of the hob.