Zanussi ZKT 621 LN 설치 및 운영 지침 매뉴얼 - 페이지 13

{카테고리_이름} Zanussi ZKT 621 LN에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZKT 621 LN 18 페이지. Elektric ceramic glass hob
Zanussi ZKT 621 LN에 대해서도 마찬가지입니다: 작동 및 설치 지침 (22 페이지)

페이지 인쇄

What to do if ...

Problem

The cooking zones are not func-

tioning.

The cooking zones cannot be se-

lected / Appliance does not react to

the control panel input

The residual heat indicator is not

displaying anything

Er03

is displayed

Er21

is displayed

Er25

is displayed

(only for 10 seconds)

Er40

is displayed

In the event of any other fault codes that arise,

disconnect the appliance from the electrical

supply for a few seconds. (Take out the fuse

from the house's wiring system.) If the fault is

displayed again, please call the Customer

Care Department and inform them of the fault

code.

If you are unable to remedy the problem by fol-

lowing the above suggestions, please contact

your dealer or the Customer Care Department.

Warning! Repairs to the appliance are only to

be carried out by qualified service engineers.

Considerable danger to the user may result

from improper repairs.

If the appliance has been wrongly operated,

the visit from the customer service technician

or dealer may not take place free of charge,

even during the warranty period.

Possible cause

No cooking zone selected

More than 10 seconds have passed

since the appliance was switched

The child safety device is activated

The sensor fields are partly covered

by a damp cloth or with liquid

Safety cut-out has been triggered

The cooking zone was only on for a

short time and is therefore not hot

Several sensor fields were touched

at the same time

Safety cut-out due to overheating

Appliance is incorrectly connected

The overvoltage protector has been

activated (for an incorrect connec-

tion see above Er25 or for over-

heating of the electronic

components see Er21)

Remedy

Select cooking zone within 10 sec-

onds of switching on (Decimal point

lights up)

Switch on the appliance again.

Select cooking zone within 10 sec-

onds of switching on

Deactivate the child safety device

(See section "Child safety device")

Remove the cloth or the liquid

Switch on the appliance again

If the cooking zone is supposed to

be hot, call the Customer Service

Department.

Only touch one sensor field

Let the appliance cool down.

Remove cookware.

Disconnect the appliance from the

electrical supply and have it con-

nected properly

Separate the appliance from the

mains for a few minutes (remove

the mains fuse).

Let the appliance cool down.