Zanussi ZF711W 지침 책자 - 페이지 9
{카테고리_이름} Zanussi ZF711W에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZF711W 20 페이지. Zanussi instruction freezer zf711w
페이지 인쇄Defrosting the freezer
A certain amount of frost will always form on the
freezer shelves and around the top compartment.
Defrost the freezer when the frost layer reaches a
thickness of about 3-5 mm.
Remove the freezer drawers and place them on top
of each other by turning every other drawer one half
turn. Put insulating material around the drawers, e.g.
blankets or newspapers.
The frozen products can also be packed closely
together and be kept in a cold location, e.g. in the
fridge.
Defrosting can be accelerated by placing bowls with
hot water (not boiling) inside the freezer.
Take out the drain spout and place it in the bottom
freezer drawer where water can collect.
Loosen the ventilation grille to enable the bowl to fit
under the drain spout.
Carefully scrape off the ice when it starts to thaw.
Use a wood or plastic scraper. Do not use sharp
objects as these may damage the interior.
When all the ice has melted, clean and wipe the
cabinet dry, then push the drain spout back in place.
Switch on the cabinet and replace the frozen
foodstuff.
When the appliance is not in use
Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Something Not Working
Before contacting your local Service Force Centre check the following points:
Symptom
The temperature is too high inside the
freezer.
The temperature is too low inside the
freezer.
Too much frost and ice are produced.
Never use a hair dryer or other heating
appliances to speed up defrosting. Excessive
heat may damage the plastic interior, and
humidity could enter the electric appliance
making it live.
Set a lower temperature.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
If warm food products have been put inside the freezer, wait for
a couple of hours and then check the temperature again.
Distribute the food products to allow cold air to circulate
around them.
Set a warmer temperature.
Fast Freeze could have been switched on.
Make sure that the door is completely closed and that the
rubber door seal is complete and clean.
Set a warmer temperature.
9
Solution
Zanussi 818 15 02--03/3