Zanussi ZFC 622 WA 사용자 설명서 - 페이지 3

{카테고리_이름} Zanussi ZFC 622 WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFC 622 WA 8 페이지.
Zanussi ZFC 622 WA에 대해서도 마찬가지입니다: 사용자 설명서 (28 페이지)

페이지 인쇄

Electrical connection

The appliance is supplied with a 13amp plug fitted. In the event of having to change the

fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used. Should

the plug need to be replaced for any reason. The wires in the power supply cable are

coloured in accordance with the following code:

Green and Yellow - Earth: must be connected to the terminal marked with the letter "E"

or by the earth symbol or coloured green and yellow.

Blue - Neutral: must be connected to the terminal "N" or coloured black.

Brown - Live: must be connected to the terminal marked "L" or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord

clamp must be secure over the outer sheath.

Warning! This appliance must be earthed.

First use

Before first use, the freezer should be cleaned inside, see chapter "Care and cleaning".

Plug in the appliance and allow the freezer to run for several hours before placing food inside.

Switch on-off

Switch on the freezer

Turn the thermostat knob to a postion between

Switch off the freezer

Turn the thermostat knob to the Off position.

Daily use

Temperature adjustment

To adjust the temperature of the freezer, proceed as follows:

Turn the thermostat knob clockwise towards

Turn the thermotat knob counter-clockwise towards

Storage baskets

Hang the baskets on the upper edge (X) or place the stackable baskets inside the freez-

er (Y).

Turn and fix the handles for these two positions, as shown in the drawings.

Spare baskets can be obtained from your local Service Force

Centre or from the Electrolux website (depending on country).

The illustrations on this page show how many baskets can be

placed in the various freezer models.

Opening and closing the lid

As the lid is fitted with a tightly closing seal, it will not re-open easily immediatedly after closing.

Wait a few minutes before re-opening the lid. The vacuum release will allow the lid to be re-opened easily. Never pull

the handle with immense force.

Care and Cleaning

Defrosting the freezer

When the ice layer is 10-15 mm thick, the freezer should be defrosted. We suggest that you defrost your freezer when

there is little or no food inside.

Disconnect the appliance from the power supply.

Remove the contents of the freezer, wrap them in newspapers, and keep them in a cold place.

Leave the appliance lid open.

Remove the plug from the water drain.

The defrost water can be collected in a tray as shown in the drawing. If available, use the divider.

Dry the interior of the appliance thoroughly.

Remember to replace the plug in the water drain.

Important! Never use a knife or any other sharp implement to remove frost or ice.

and

for a colder storage temperature.

for a less cold storage temperature.