Zanussi ZFC1042WA 사용자 설명서 - 페이지 3

{카테고리_이름} Zanussi ZFC1042WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFC1042WA 44 페이지.

페이지 인쇄

• Do not use mechanical devices or other means to accelerate

the defrosting process, other than those recommended by the

manufacturer.

• Do not damage the refrigerant circuit.

• Do not use electrical appliances inside the food storage com-

partments of the appliance, unless they are of the type recom-

mended by the manufacturer.

• Do not use water spray and steam to clean the appliance.

• Clean the appliance with a moist soft cloth. Only use neutral de-

tergents. Do not use abrasive products, abrasive cleaning pads,

solvents or metal objects.

• Do not store explosive substances such as aerosol cans with a

flammable propellant in this appliance.

• If the supply cord is damaged, it must be replaced by the manu-

facturer, its service agent or similarlyqualified persons in order to

avoid a hazard.

Safety Instructions

Installation

WARNING! Only a qualified person

must install this appliance.

• Remove all the packaging.

• Do not install or use a damaged appliance.

• Obey the installation instruction supplied

with the appliance.

• Always be careful when you move the ap-

pliance because it is heavy. Always wear

safety gloves.

• Make sure the air can circulate around the

appliance.

• Wait at least 4 hours before connecting the

appliance to the power supply. This is to

allow the oil to flow back in the compressor.

• Do not install the appliance close to

radiators or cookers, oven or hobs.

• The rear of the appliance must stand

against the wall.

• Do not install the appliance where there is

direct sunlight.

www.zanussi.com

• Do not install this appliance in areas that

are too humid or too cold, such as the

construction appendices, garages or wine

cellars.

• When you move the appliance, lift it by the

front edge to avoid scratching the floor.

Electrical connection

WARNING! Risk of fire and electrical

shock.

• The appliance must be earthed.

• All electrical connections should be made

by a qualified electrician.

• Make sure that the electrical information on

the rating plate agrees with the power sup-

ply. If not, contact an electrician.

• Always use a correctly installed shockproof

socket.

• Do not use multi-plug adapters and exten-

sion cables.