Zanussi ZFC21400WA 사용자 설명서 - 페이지 14
{카테고리_이름} Zanussi ZFC21400WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFC21400WA 49 페이지.
Zanussi ZFC21400WA에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지)
페이지 인쇄
WARNING: Do not damage the refrigerant circuit.
•
WARNING: Do not use electrical appliances inside the food
•
storage compartments of the appliance, unless they are of the
type recommended by the manufacturer.
Do not use water spray and steam to clean the appliance.
•
Clean the appliance with a moist soft cloth. Only use neutral
•
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
•
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
SAFETY INSTRUCTIONS
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
•
Remove all the packaging.
•
Do not install or use a damaged appliance.
•
Follow the installation instructions supplied with
the appliance.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Make sure the air can circulate around the
appliance.
•
At first installation or after reversing the door
wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
•
Before carrying out any operations on the
appliance (e.g. reversing the door), remove the
plug from the power socket.
•
Do not install the appliance close to radiators or
cookers, ovens or hobs.
•
Do not expose the appliance to the rain.
•
Do not install the appliance where there is direct
sunlight.
•
Do not install this appliance in areas that are too
humid or too cold.
•
When you move the appliance, lift it by the front
edge to avoid scratching the floor.
14
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
WARNING! When positioning the
appliance, ensure the supply cord is
not trapped or damaged.
WARNING! Do not use multi-plug
adapters and extension cables.
•
The appliance must be earthed.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Always use a correctly installed shockproof
socket.
•
Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Authorised Service
Centre or an electrician to change the electrical
components.
•
The mains cable must stay below the level of the
mains plug.
•
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.