Zanussi ZFC340WAA 사용자 설명서 - 페이지 4
{카테고리_이름} Zanussi ZFC340WAA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFC340WAA 20 페이지. Chest freezer
Zanussi ZFC340WAA에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지)
페이지 인쇄
Operation
Switching on
Insert the plug into the wall socket.
The Pilot light will light up.
Turn the Temperature regulator clockwise.
Important! If the temperature inside the appliance is too
high the Alarm light will light up.
Switching off
To turn off the appliance, turn the Temperature regulator
to the OFF position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator towards
the minimum coldness.
• turn the Temperature regulator towards
the maximum coldness.
Control panel
5
Pilot light
1
High temperature alarm light
2
Fast Freezing light
3
Fast Freezing switch
4
First use
Cleaning the interior
Before using the appliance for the first time, wash the inte-
rior and all internal accessories with lukewarm water and
4
to obtain
to obtain
1
2
3
4
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the lid is opened
• the quantity of food stored
• the location of the appliance.
Temperature regulator
5
Fast Freezing function
You can activate the Fast Freezing function by pressing
the Fast Freezing switch.
The Fast Freezing light will light up.
It is possible to deactivate the function at any time by
pressing the Fast Freezing switch. The Fast Freezing light
will switch off.
High temperature alarm
An increase in the temperature in the freezer (for example
due to an power failure) is indicated by switching on of
the Alarm light
During the alarm phase, don't place food inside the freez-
er.
When normal conditions are restored the Alarm light will
switch off automatically.
some neutral soap so as to remove the typical smell of a
brand-new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders, as
these will damage the finish.