Zanussi ZFT 410W 지침서 - 페이지 31

{카테고리_이름} Zanussi ZFT 410W에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFT 410W 48 페이지.

페이지 인쇄

Switch and indicator unit

For the usage of the switching and indicator unit see

chapters "Putting it into use", "Controlling the

temperature" and "Freezing".

Components of the appliance are as follows:

Green indicator lamp

This lamp lights when the appliance is under power,

i.e. the mains plug is in the mains socket.

B) Red indicator lamp

It lights up depending on the temperature inside the

appliance.

It lights for a short time when starting the appliance,

placing fresh food into it and when the temperature

control knob has been turned in direction to lower

temperatures.

It lights permanently when the temperature inside

the appliance is too high (overloaded with warm

food, door stayed open or the door seal does not

close properly) or possibly the appliance was

broken down.

C) Yellow indicator lamp and freezer switch

In the switched-on state of the switch (pops up and

lights by pressing) the compressor operates

continuously thus providing for the coldest interior

temperature - achievable by the freezer - needed for

freezing.

D) Temperature control knob

This knob is provided for setting and changing the

temperature inside the appliance.

Handling the appliance

Putting it into use

Put the plug into the mains socket. Turn the thermostatic

control knob according to the figure. This time the red

lamp starts giving light, the compressor starts and

cooling begins shortly.

When the red light goes out the temperature is sufficient

and the appliance is suitable for storing frozen and deep-

frozen foods.

Controlling the temperature

The thermostatic controller interrupts the operation of the

appliance automatically for more or less time depending

on the setting then restarts it assuring the required

temperature.

Setting the thermostat knob can be done practically with

a coin. Turning the control knob clockwise cooling

becomes more and more intensive.

Downloaded from Fridge-Manual.com Manuals

In the appliance -18 °C or lower temperature can be

reached if the thermostat knob is set according to the

figure.

The thermostat can be switched off („0" position), which

means breaking the circuit of the compressor i.e.

stopping cooling.

The temperature coming about in the freezer is effected

by not only the position of the thermostatic control and

the ambient temperature, but frequency of door openings

and the quantity of food put into it, etc.

In maximum position of the thermostat - in case of

increased demand e.g. during heatwaves - the

compressor may operate continually. This does not

cause damages to the appliance.

Freezing

Freezing different products should always be done in the

freezing compartment after proper preparation.

Move frozen food from the top drawer into the other two

drawers. For maximum freezing performance remove the

top drawer and then place the foods to be frozen directly

on the evaporator. In case of freezing smaller food

volumes you do not need to remove the drawer.

Switch on the freezer switch (pops up and lights by

pressing) 4 hours before freezing food of small quantities

and about 24 hours before freezing products of larger

quantities. This time the compressor operates continuously

to reach the temperature necessary for freezing.

Place in the foods to be frozen and let the appliance

operate for about 24 hours as written above.

Then push the fast freezer switch again (the yellow light

will go out and the switch turns to its original position).

Move the fresh frozen food into the top drawer and insert

the drawer in the appliance in its working position.

Storing

It is practical to replace frozen products into the storing

compartments after freezing has finished so that to make

room in the freezing compartment for another freezing.

In large quantities of food are to be stored, remove the

baskets except the lowermost one from appliance and

place food on the shelves.

Intermediate freezing does not deteriorate foods already

stored.