Zanussi ZFT10210WV 사용자 설명서 - 페이지 9
{카테고리_이름} Zanussi ZFT10210WV에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFT10210WV 17 페이지.
페이지 인쇄
Problem
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Water flows on the floor.
Temperature cannot be set.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The QuickFreeze function is
switched on.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
Food products are not wrap-
ped properly.
This is normal, no error has oc-
curred.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The QuickFreeze function is
switched on.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
The QuickFreeze function is
switched on.
There is no cold air circulation
in the appliance.
Solution
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "QuickFreeze func-
tion".
Refer to "Closing the door".
Wrap the food products better.
The compressor starts after a
period of time.
Attach the melting water outlet
to the evaporative tray.
Switch off QuickFreeze man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Quick-
Freeze function"
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "QuickFreeze func-
tion".
Make sure that there is cold air
circulation in the appliance.
9