Zanussi ZFU23404WA 사용자 설명서 - 페이지 14
{카테고리_이름} Zanussi ZFU23404WA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFU23404WA 33 페이지.
Zanussi ZFU23404WA에 대해서도 마찬가지입니다: 사용자 설명서 (33 페이지)
페이지 인쇄
Problem
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to the
desired result, contact the nearest
Authorised Service Centre.
INSTALLATION
WARNING! Refer to Safety chapters.
POSITIONING
This appliance can be installed in a dry, well
ventilated indoor where the ambient temperature
corresponds to the climate class indicated on the
rating plate of the appliance:
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
ELECTRICAL CONNECTION
•
Before plugging in, ensure that the voltage and
frequency shown on the rating plate correspond
to your domestic power supply.
14
Possible cause
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
•
The appliance must be earthed. The power
supply cable plug is provided with a contact for
this purpose. If the domestic power supply
socket is not earthed, connect the appliance to
a separate earth in compliance with current
regulations, consulting a qualified electrician.
•
The manufacturer declines all responsibility if
the above safety precautions are not observed.
•
This appliance complies with the E.E.C.
Directives.
INSTALLATION OF THE APPLIANCE AND
DOOR REVERSAL
Solution
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Set a higher/lower temperature.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Please refer to separate instructions
on installation (ventilation
requirements, levelling) and door
reversal.