Zanussi ZFV 190 P 지침 책자 - 페이지 6

{카테고리_이름} Zanussi ZFV 190 P에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZFV 190 P 12 페이지.

Door reversal directions

Before starting work, unplug the appliance. To reverse

the opening direction of the door proceed as follows:

Remove the lower hinge (3), the pin (1) and the screw

(2);

slide the door out from the pin (5), remove the pin and

place it on the opposite side;

unscrew the foot front left and place it on the opposite

side;

unscrew the two screws which mask the holes for

ﬁxing the hinge on the front left side;

reassemble the door;

reﬁt the lower hinge (turning it 180 ), the pin and the

screw on the opposite side, as shown in the ﬁgure.

remove the handle, after having removed the screw

cover and reﬁt it on the opposite side.

The holes that are not used must be masked with the

plastic plugs removed.

Attention

After completion of the door reversibility operation,

check that the door gasket adheres to the cabinet. If

the ambient temperature is cold (i.e. in Winter), the

gasket may not ﬁt perfectly to the cabinet. In that

case, wait for the natural ﬁtting of the gasket or

accelerate this process by heating up the part involved

with a normal hairdrier.

(for models equipped with door frame)

To ﬁt the door panel, proceed as follows:

– remove the ﬁxing screws and remove the frame

side opposite the handle;

– loosen, without removing them, all remaining

screws ﬁxing the door frame;

– insert the panel from the side on which the frame

has been removed and push it fully in;

– reﬁt the frame side and tighten all the screws.

Note

The panel size should be 1-2 mm smaller than the

door; the maximum permissible panel thickness is

4 mm.

D548

D299

D162

Fig. 3

Fig. 3a

Fig. 3b