Zanussi ZNLN31EW2 사용자 설명서 - 페이지 14

{카테고리_이름} Zanussi ZNLN31EW2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZNLN31EW2 21 페이지.

Zanussi ZNLN31EW2 사용자 설명서
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
The compressor operates con-
tinually.
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
Side panels of the appliance
are warm.
The lamp does not work.
14
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The FastFreeze function is
switched on.
The compressor starts after a
period of time.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
This is a normal state caused
by operation of the heat ex-
changer.
The lamp is in stand-by mode.
The lamp is defective.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Control Panel" chap-
ter.
Wait a few hours and then
check the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door"
section.
Refer to "FastFreeze function"
section.
This is normal, no error has oc-
curred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of the
door.
Make sure the appliance instal-
lation is done according to the
instructions given in this user
manual.
Close and open the door.
Contact the nearest Author-
ized Service Centre.