Zanussi ZQF11432DA 사용자 설명서 - 페이지 9
{카테고리_이름} Zanussi ZQF11432DA에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZQF11432DA 16 페이지.
페이지 인쇄
Problem
The appliance is noisy.
Audible or visual alarm is on.
Power indicator light is flashing.
The compressor operates contin-
ually.
There is too much frost and ice.
www.zanussi.com
Possible cause
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on or the temperature is
still too high.
The temperature in the appliance
is too high.
The door is left open.
An error has occurred in measur-
ing the temperature.
The appliance is not working
properly.
The temperature in the appliance
is too high.
Temperature is set incorrectly.
Many food products to be frozen
were put in at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly.
The QuickFreeze function is
switched on.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
Solution
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Close the door.
Contact a qualified electrician or
contact the nearest Authorized
Service Centre.
Contact a qualified electrician or
contact the nearest Authorized
Service Centre.
Contact a qualified electrician or
contact the nearest Authorized
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "QuickFreeze function".
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
9