Zanussi ZV 130 E 지침 책자 - 페이지 9

{카테고리_이름} Zanussi ZV 130 E에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZV 130 E 11 페이지.

페이지 인쇄

Periods of non-operation

When the appliance is not in use for long periods, take

the following precautions:

remove the plug from the wall socket;

remove all food:

defrost and clean the interior and all accessories;

leave the door ajar to allow air to circulate to prevent

unpleasant smells.

SOMETHING NOT WORKING

If the appliance is not functioning properly, check that:

Dérangement

Appliance does not function, no pilot light is illuminated.

The freezer temperature is not sufficient, red light lights up.

Large accumulation of frost in the appliance, perhaps also at

the door seal.

Unusual noises.

The compressor does not start immediately after pressing the

fast freeze button or after changing the temperature setting.

If your appliance is still not working properly after making the above checks, contact the nearest service centre.

To obtain fast service, it is essential that when you apply for it you specify the model and serial number

of your appliance which can be found on the guarantee certificate or on the rating plate located inside

the appliance, on the bottom left-hand side.

Malfunctions

If the electronics in the appliance have detected a fault that prevents the ACTUAL temperature being measured,

the warning light in the temperature display will flash. The appliance will continue to function using a backup

program until customer service has repaired the appliance.

- Appliance is not switched on; switch appliance on.

- Mains plug is not inserted or is loose; insert mains plug.

- Fuse has blown or is defective; check fuse, replace if

necessary.

- Mains socket is defective; Mains malfunctions are to be

corrected by an electrician.

- Temperature is not properly adjusted; please refer to the

section "Temperature regulation".

- Door was open for a long time; only leave the door open

as long as necessary.

- Within the last 24 hours a large quantity of warm foods

were loaded; press the fast freeze button.

- Appliance is next to a source of warmth; please refer to the

section "Location".

- Door is not properly sealed (perhaps after re-hanging

door); carefully warm the door seal with a hand-held hair

dryer at those points which are not airtight (no warmer

than approx. 50°C). At the same time, shape the warmed

door seal by hand, so that it is again properly seated.

- Appliance is not level; readjust the front levelling feet.

- Appliance is in contact with wall or other objects; push

appliance away a short distance.

- A part at the back of the appliance, e.g. a tube, is in

contact with another appliance part or the wall; bend this

part away carefully if necessary.

- This is normal, no error has occurred; the compressor

starts after a period of time.

Remède