Zanussi ZV280R 지침 책자 - 페이지 11

{카테고리_이름} Zanussi ZV280R에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZV280R 12 페이지.
Zanussi ZV280R에 대해서도 마찬가지입니다: 지침 책자 (13 페이지), 지침 책자 (12 페이지)

페이지 인쇄

Mounting of door panels

The door can be decorated with panels. If youcabinet

is not equipped with door frames, they can be

orderd seperately.

1. Remove the handel and the frame of the side

where the handle is fitted.

2 Loosen the screws of the other frames.

3 Adjust the panel and screw it in place.

4. Mount the removed frame and the handle.

Measurements fo the door panels:

Height

(mm)

ZV280P-1

1436

ZV320P-1

1636

Door Reversal

)

1. Close the cabinet and remove the plug from the

electrical socket.

2. Remove the ventilation grille. There is a part on

the grille that can be removed. Reposition it and put

it on the other side.

3. Put the cabinet on a wooden board when it is laid

down. Later, when raising the cabinet, it will be

easier to grip under the cabinet thanks to the board.

4. On the upper part of the cabinet. Move the hinge

pin and cover washer.

5. On the lower part of the cabinet. Unscrew the

hinge. Move the hinge pin and plastic cover. Secure

the hinge on the other side.

6. Raise the cabinet and replace the ventilation grille.

7. Unscrew the handle. Carefully press in the plastic

plugs on the opposite side using a drift. Secure the

handle in the plug holes. Then press the supplied

plastic plugs into the holes to which the handle was

previously fitted.

8. Put the cabinet in position. Check that it stands

straight. See the section "Positioning the cabinet".

Electrical connection

Connect the cabinet to a grounded electrical outlet.

Voltage: 230 V.

Fuse: 10 A.

Refer to the rating plate on the left inside the

cabinet.

Width

Depth

(mm)

584

4max

584

4max

Zanussi 818 14 97-02/8