Zanussi ZYAN8FW0 사용자 설명서 - 페이지 14

{카테고리_이름} Zanussi ZYAN8FW0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZYAN8FW0 21 페이지.
Zanussi ZYAN8FW0에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)

페이지 인쇄

Problem

Water flows on the floor.

The temperature in the appli-

ance is too low/too high.

If the advice does not lead to the

desired result, call the nearest

Authorized Service Centre.

CLOSING THE DOOR

1. Clean the door gaskets.

Possible cause

The melting water outlet is not

connected to the evaporative

tray above the compressor.

The temperature is not set cor-

rectly.

The door is not closed correct-

ly.

The food products' tempera-

ture is too high.

Many food products are stored

at the same time.

The thickness of the frost is

greater than 4-5 mm.

The door has been opened of-

ten.

There is no cold air circulation

in the appliance.

2. If necessary, adjust the door. Refer to

"Installation" chapter.

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

Solution

Attach the melting water outlet

to the evaporative tray.

Set a higher/lower tempera-

ture.

Refer to "Closing the door"

section.

Let the food products temper-

ature decrease to room tem-

perature before storage.

Store less food products at the

same time.

Defrost the appliance.

Open the door only if necessa-

ry.

Make sure that there is cold air

circulation in the appliance.

Refer to "Hints and Tips" chap-

ter.