Clarke AIR PIONEER 100 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke AIR PIONEER 100에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke AIR PIONEER 100 8 페이지.

페이지 인쇄

The Pressure Switch should not require adjustment. This is an automatic device

and has been pre-set at the factory to stop the motor when the pressure in

the receiver reaches its maximum (115 psi), and to start it again when the

pressure in the receiver falls to the minimum precept value. This operation is

completely automatic and does not affect the spraying process in any way.

NOTE:

If the machine pumps continuously without cutting-out then the compressor

is too small for the application/tool being used, and damage to the

machine may result.

SHUTTING DOWN THE COMPRESSOR

Press the ON/OFF switch to the off 'O' position.

NEVER USE THE MAINS SWITCH TO STOP THE MOTOR.

IMPORTANT!...... ALWAYS depress equipment trigger (spraygun) to release air

from the hose and compressor BEFORE disconnecting from the machine.

Switch off and disconnect from the mains supply.

MAINTENANCE

After the first 5 hours of running the compressor, check the cylinder head bolts

and motor housing, screws and re-tighten if any have worked loose.

Check the oil level every time you start working and top-up if necessary (use

Clarke SAE 40 compressor oil).

After the first 50 hours use, replace the

oil completely (use Clarke SAE 40

compressor oil) and then, after every 100

hours. To empty the oil from the

machine, remove the screw on the front

of the crankcase cover (fig.7).

Every 50 hours use, remove the black

plastic air filter (fig.8), then unclip the

back cover.

Remove the filter and wash it in clean

soapy water. Allow to dry completely

before reassembling. Renew the filter if

it is badly contaminated or damaged in

any way.

At least once a week drain the

condensate from the receiver by

unscrewing the drain plug underneath

the air receiver (fig.9).

NOTE: If the compressor is used on a daily

basis, then the tank should be drained before

each use.

Fig. 9

In the event of an air leak follow the

procedure below:

•

Load compressor to maximum pressure

•

Unplug the compressor

•

With a brush and soapy water wet all

'screwed' connections

•

Any leaks will show through the

formation of air bubbles

NEVER UNSCREW A CONNECTION WHILE THE

RECEIVER TANK IS UNDER PRESSURE...ALWAYS

MAKE CERTAIN THAT THE TANK HAS FIRST

BEEN EMPTIED.

Fig. 7

Fig.8