Zanussi ZHC 9254X 사용자 설명서 - 페이지 17

{카테고리_이름} Zanussi ZHC 9254X에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHC 9254X 28 페이지. Zanussi washer dryer brochure
Zanussi ZHC 9254X에 대해서도 마찬가지입니다: 사양 (7 페이지)

페이지 인쇄

Make sure that the cooker hood is disconnected from the power supply before carrying out

the installation.

Remove the anti-fat filter and the carbon filter support frame.

• Mark the wall with a centre line, this will aid mounting procedure (1), position the template so that

the mid line printed on the template matches with the centre line previously drawn, the lower side

of the template corresponds to the lower side of the hood once mounted (2).

• Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws (3). Hang the

hood (4) and adjust its position (5-6).

• From the inside of the hood sign 1 point for definitive fixing (7).

• Remove the hood (8) and drill 1 hole Ø 8mm (9), fit 1 wall plug (10).

• Drill two holes Ø 8mm on the upper side close to the ceilling, fit two wall plugs (11) (In case the

hood is to be used in filter version, mount the deflector F on the chimney support with 4 screws)

and fix the chimney support G with two screws (12).

• Hang the hood again (13) and fix it definitively with 1 screw (14).

• Fit an exhausting pipe (15) to connect the outlet hole B of the hood to the outside (Extractor

hood) or to the deflector F (Filter version).

• Make electrical connection (16).