Zanussi ZHC 94 설치, 사용 및 유지보수 핸드북 - 페이지 5

{카테고리_이름} Zanussi ZHC 94에 대한 설치, 사용 및 유지보수 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHC 94 9 페이지.
Zanussi ZHC 94에 대해서도 마찬가지입니다: 설치, 사용 및 유지보수 핸드북 (11 페이지)

Zanussi ZHC 94 설치, 사용 및 유지보수 핸드북

INSTALLATION

Wall marking:
• Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre
of the area in which the hood will be installed.
• Draw a horizontal line at 650 mm above the hob.
• Place bracket 7.2.1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning
the centre (notch) with the vertical reference line.
• Mark the wall at the centres of the holes in the bracket.
• Place bracket 7.2.1 on the wall as shown at X mm below the first bracket (X = height of the upper
chimney section supplied), aligning the centre (notch) with the vertical line.
• Mark the wall at the centres of the holes in the bracket.
• Mark a reference point as indicated at 116 mm from the vertical reference line and 320 mm above
the horizontal reference line.
• Repeat this operation on the other side.
• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the lower bracket 7.2.1 using the 12a screws (4,2 x 44,4) supplied.
• Fix the upper bracket 7.2.1 and the air outlet connection support 7.3 together using the 2 screws
12a (4,2 x 44,4) supplied.
• Insert the two screws 12a (4,2 x 44,4) supplied in the hood body fixing holes, leaving a gap of 5-
6 mm between the wall and the head of the screw.
GB

Wall drilling and bracket fixing

7.2.1
11
116
12a
116
12