Zanussi ZHP 613 사용 설명서 - 페이지 12
{카테고리_이름} Zanussi ZHP 613에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZHP 613 40 페이지.
Zanussi ZHP 613에 대해서도 마찬가지입니다: 설치, 사용 및 유지보수 핸드북 (40 페이지)
INSTALLATION
Drilling the Support surface and Fit-
ting the Hood
SCREW FITTING
• The hood support surface must be 135 mm
above the bottom surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using
the drilling template provided.
• Cut a hole ø 125 mm in size on the support sur-
face, using the drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provid-
ed.
SNAP-ON FITTING
• The hood can be installed either directly on the
bottom surface of the wall units using snap-on
side supports.
• Cut a fitted opening in the bottom surface of the
wall unit, as shown.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf from
underneath the hood.
CLOSING ELEMENT
• The space between the edge of the hood and the
rear wall can be closed by applying the element
20 provided, using the screws supplied for this
purpose.
GB
���
���
���
���
��
��
��
12