Clarke Air XP15 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke Air XP15에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Air XP15 17 페이지. 150l engine driven air compressor

STARTING THE COMPRESSOR

1. At the beginning of the day, open the drain cock and allow any

condensate to drain completely, then close the drain cock.

2. To ease starting, ensure there is

no pressure in the pump outlet

manifold by opening the Bleed

valve.

3. Connect the air hose to the air

outlet.

4. Connect your air tool to the air

hose.

• Make sure that the air outlet

tap is closed

5. Start the engine in accordance with the instructions contained in the

engine service manual, If this is the first time you are using the compressor,

allow it to run for 10 minutes.

6. Close the bleed valve fully.

• Pressure will build up in the receiver and eventually the air governor will

operate so that the engine runs off load.

• The pressure registered on the pressure guage should be 100psi.

7. Use your air tool as prescribed in its user guide.

• When the pressure has dropped by approximatley 20psi the compressor

will start up again.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]