Zanussi Z 8050 WOS 사용 지침 및 설치 지침 - 페이지 7

{카테고리_이름} Zanussi Z 8050 WOS에 대한 사용 지침 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi Z 8050 WOS 37 페이지. Cooker z 8050 wos

페이지 인쇄

ELECTRIC SPARK IGNITION

To light the burner you have to rotate

the knob corresponding to the specific

burner to the maximum flame position

(large flame symbol) and press the igni-

tion button marked by the symbol

(fig. 3.3).

The sparks produced by the electrodes

situated next to the burner will light the

selected burner.

If conditions of the local gas supply

makes it difficult to light the gas burner

with the knob set to the high flame

position, rotate the knob to the lower

flame position and repeat the ignition.

If the burner flame should go out

accidentally wait for at last 1 minute

before re-light the burner.

Fig. 3.2

Fig. 3.3

CHOICE OF THE BURNER

On the control panel, near every knob,

there is a diagram that indicates which

burner is controlled by that knob.

The suitable burner must be chosen

according to the diameter and the

capacity used.

As an indication, the burners and the

pots must be used in the following way:

BURNERS

Auxiliary

Semi-rapid

Rapid

Double-ring

do not use pans with concave or convex bases

Fig. 3.4

It is important that the diameter of the

pot be suitable to the potentiality of the

burner so as not to compromise the high

output of the burners and therefore

energy waste.

A small pot on a large burner does not

give you a boiling point in a shorten

amount of time since the capacity of

heat absorption of a liquid mass

depends on the volume and the surface

of the pot.

N.B. When the cooker top is not

being used, set the gas knobs

to their closed positions and

also close the cock valve on

the gas bottle or the main gas

supply line.

POT DIAMETER

12 - 16 cm

16 - 22 cm

20 - 24 cm

up to 30 cm