Zanussi Z 9060 XOS 사용 지침 및 설치 지침 - 페이지 16

{카테고리_이름} Zanussi Z 9060 XOS에 대한 사용 지침 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi Z 9060 XOS 37 페이지. Cookers z 9060wos; z 9060 xos

BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if cleaned
with products used for silverware.
After cleaning or wash, check that burner-
caps and burner-heads are dry before pla-
cing them in the respective housings.
Special attention has to be paid in
order not to exchange the housing of
the two small burners shown in fig. 6.2.
It is absolutely necessary to check the
perfect housing of the burner-ring as an
incorrect housing may cause serious
inconvenience.
Check also that the electrodes for igni-
tion be always clean in order to ensure a
regular spark shooting.
Burner-cap ring
partially drilled
16
Fig.
6.2
Burner-cap ring
fully drilled
CLEANING
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice,
tomato sauce, vinegar etc. can damage
the enamel if left too long.
STAINLESS STEEL, ALUMINIUM
PARTS AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be clea-
ned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
CAUTION: Do not use abrasive sub-
stances or non-neutral detergents as
these will irreparably damage the pro-
tective surface.

REPLACING THE OVEN LIGHT BULB

Switch the cooker off at the mains.
Unscrew and replace the bulb with
another one resistant to high temperatu-
res (300°C), voltage 230 V (50 Hz), 15
W, E14.
INSIDE OF OVEN
This must be cleaned every time it is
used.
Remove and refit the side runner frames
as described on the next chapter.
With the oven warm, wipe the inside
walls with a cloth soaked in very hot
soapy water or another suitable product.
The bottom of the oven, side runner fra-
mes, tray and rack can be removed and
washed in the sink.