Zanussi ZC 605 M 매뉴얼 - 페이지 16
{카테고리_이름} Zanussi ZC 605 M에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZC 605 M 18 페이지. Electrogas cooker
페이지 인쇄
ADAPTATION TO DIFFERENT
KINDS OF GAS
To adapt the appliance to a different kind of gas from
the one the appliance has been set for, follow the
instructions below in their order.
GAS CONNECTION (Fig. 15)
LPG : use the rubber pipe holder «C».
Natural gas : use the pipe fitting «A».
Always insert the gasket «B» (Fig. 15). Then proceed
with the gas connection, as indicated in the relevant
paragraphs.
HOB BURNERS
NOZZLES REPLACEMENT
- Remove the pan supports.
- Extract the caps and the wall baffles of the burners.
- Using a socket spanner 7 unscrew and remove (fig.
16) the nozzles replacing them with the ones required
for the kind of gas in use (see table).
Reassemble the parts following the same procedure
backwards.
These burners do not need any primary air regulation.
HOB BURNERS
ADJUSTMENT OF MINIMUM LEVEL
To adjust the minimum level:
1)
turn the knob to the position of minimum flame;
2)
remove the knob (Fig. 17);
3a) in case of conversion from natural gas to LPG,
tightly screw the by-pass screw of the cocks;
3b) when converting from LPG to natural gas unscrew
about one-fourth turn by-pass screw, until a
regular small flame is reached.
Reassemble the parts following the same procedure
backards.
Check that, turning quickly the knob from the maximum
position to the minimum one, the flame does not go out.
BURNER
Auxiliary
Semi-rapid
Rapid
70
Normal power
Reduced power
kW
1
2
Natural gas:
3
LPG : 2,8
Fig. 14
Fig. 15
Fig. 16
NATURAL GAS
Mark
1/100
G20
kW
mbar
0,33
70
0,095
0,45
96
0,190
0,65
119
0,286
FO 2127
FO 0392
LPG
3
m
/h
Mark
1/100
G25
G 30
20
25
mbar
0,111
50
72,5
0,221
71
145
0,332
86
203
g/h
G 31
71,5
143
200